Avidyne Entegra EXP5000 Manual de instalación descargar pdf (Pagina 42)

Installation Manual

GPS/FMS Navigators Setup P/N 600-00175-000 Rev 04

- 32 -

■ Speed—There are two speeds available, High and Low. See Table 12, “GPS/FMS

Manufacturer’s Matrix,” on page 30 to determine the correct speed for your system.

3. When you are done, press Save to save your changes. Press Cancel to exit without saving

changes.

4. Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,

press Restart System.

5.5.2 Dual GPS Setup with GAMA 429

The EX500/EX600 can receive information from two GAMA 429 Graphics capable GPS units. Connect

the GPS according to the wiring diagram in Appendix G: GPS/FMS System Wiring, on page 96, using

a different ARINC port for GPS2. Follow the setup instructions in Section 5.5.1.

5.5.3 RS-232 Setup

If your GPS uses an RS-232 configuration, use Appendix G: GPS/FMS System Wiring, on page 96 for

wiring information.

Note: An RS-232 interface does not provide for heading data from the GPS/FMS.

➤ To set up the MFD for the RS-232 Interface:

1. From the Maintenance Mode Page, press GPS Setup. The GPS Setup Page displays.

2. Configure the interface as follows:

■ Receiver—Select the receiver-type for your GPS/FMS system. Determine the RS-232 output

format using Table 12, “GPS/FMS Manufacturer’s Matrix,” on page 30 or your GPS/FMS

Installation manual. Select one of the following RS-232 formats:

◆ NMEA 0183

◆ King/Aviation Format

◆ Northstar Format

■ Port—Select RS232 1, or as wired.

■ Baud—Select the highest-possible baud rate for your GPS/FMS system. See the appropriate

GPS/FMS Installation manual or see Table 12, “GPS/FMS Manufacturer’s Matrix,” on page 30

to determine for the maximum speed.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 123 124

Sin comentarios

Avidyne Entegra EXP5000 Manual de instalación Pagina 42