Avidyne IFD540 Manual de instalación descargar pdf (Pagina 54)

2-16 FMS Pages

LATERAL OFFSETS

The system supports a capability to create and fly a lateral offset

from your flight plan. From the “FPL” tab of the FMS page, press

the “Offset Route” LSK and use the right-hand knob on the IFD to

dial in the desired offset. Use the outer ring for coarse control (1

nm increments) and the inner ring for fine control (0.1 nm

increments). Rotate the knob left for left offsets and right for right

offsets. Once the intended offset has been entered, press the

“Confirm Right/Left x.x NM” LSK. At that point, the original LSK

will indicate “Offset Route Right/Left X.X NM”. To delete a lateral

offset, press the “Delete Offset” LSK. The maximum offset that

can be dialed in is 20 NM. Lateral offsets are not available when

in OBS mode. Lateral offsets are unaffected by graphical route

planning (“rubber banding”) operations.

Lateral Offset Map Depiction

GAPS OR DISCONTINUITIES IN FLIGHT PLANS

A “Gap In Route” will appear within the flight plan when there is a

discontinuity between legs. A discontinuity occurs when the FMS

cannot compute the guidance to the next leg due to an invalid leg

type combination based on preset guidance rules. The objective

is to inform the pilot that the Gap must be manually closed if you

wish to sequence to the next waypoint. Otherwise, the leg before

the Gap will not be sequenced and guidance will not be provided

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 225 226

Sin comentarios

Avidyne IFD540 Manual de instalación Pagina 54